Wireless Technology, Inc. that may cause undesired operation. (WTI) It is not to be copied or disclosed in any manner without the consent of Wireless READ THIS MANUAL Technology, Inc.
We appreciate your purchase of Wireless Technology, Inc. (WTI) security products. We take pride in the quality of our products and have manufactured each new WTI product to exacting quality standards. In normal use, it will provide you with years of satisfactory performance.
(RA) and provide the following information: 1.) Product Model & Serial Numbers 2.) Date of shipment, purchase order number, sales order number or WTI invoice number. 3.) Details of the defect or malfunction. If there is a dispute regarding the warranty or...
IMMIDIATELY, so that the camera can be returned to WTI for repair. This will help prevent further EXPENSIVE internal corrosion damage from occurring. Below are some examples of Damage that will compromise the sealing integrity of the camera.
Also take precautions to avoid contact between the equipment and other electrical wires or power sources that may be present at the installation site. SW720A WTI ~ Page 7 of 27...
The following table provides a quick reference to the major features available in each camera model. MODEL SW720A SW720A-ENG SW720A-MS SW720-MS-ENG SW720AP SW720AP-MS SW720HV SW720HV-ENG SW720HVP SW720A WTI ~ Page 8 of 27...
The Sidewinder SW720A camera operates on AC line voltages within a voltage range of 85VAC to 265VAC and an operating frequency of 47Hz to 63Hz. The camera umbilical cable is available terminated with an 18 Pin MS style male connector or a 16 Pin AMP style connector.
Please examine the equipment carefully when unpacking the shipping container. If any damage is noted please be sure to file a claim with the carrier. WTI is not responsible for any damage that occurs during shipping. Please verify that all of the contents are present and carefully check the packing material for any loose items before recycling it.
The camera may NOT be mounted with the base facing horizontally. The base of the Sidewinder SW720A camera has four ¼-20 screw holes that are equally spaced, 90 degrees apart, on a 4.75” diameter circle, as shown in figure 2. If mounting screws other than those provided with the camera are used, the length of the mounting screws should be selected so that the screws penetrate no more than 0.75 inches into the...
The Sidewinder SW720A camera is supplied with a 36 inch umbilical cable to allow the cable to be routed through the camera mount before the actual physical installation of the camera.
Page 14
SWWM1 + SWVPA – Wall Mount with Vertical Pole Adapter SW720A WTI ~ Page 14 of 27...
Page 15
SWPTM1 – Pole Top Mount SW720A WTI ~ Page 15 of 27...
Page 16
SWHPM1 – Horizontal Pole Mount SW720A WTI ~ Page 16 of 27...
120 VAC MS STYLE UMBILICAL CONNECTIONS SW720A-MS - 36 inch umbilical cable with an 18 pin MS style connector SW720AP-MS -36 inch umbilical cable with an 18 pin MS style connector SW720-MS-ENG -36 inch umbilical cable with an 18 pin MS style connector...
Green - 22 AWG Minimum (Same or Heavier than AC Line) SD or Green Video Output Coaxial Cable #1 RG-59 Center Green – Twisted Pair #1 22-26 AWG Pb Blue Video Output (HD Only) Coaxial Cable #3 RG-59 Center SW720A WTI ~ Page 20 of 27...
75 Ohm drive impedance on Pins L and A of the 18 pin MS connector (see wiring chart). PTZ SERIAL CONTROL PORT An RS-485 port is provided on the SW720A camera for PTZ and other camera control functions. The SW720A camera series supports several industry standard protocols, including Pelco D protocol and COHU protocol.
SURGE PROTECTION AND PRESSURIZATION SURGE PROTECTION The SW720A camera provides internal surge protection for all of the power, data and video signals. 1.) The AC line power connections are provided with 275 volt 135 Joule MOV surge arrestors rated for 6000 Amp pulses. A 3A SMT fuse is included in the primary circuit to prevent catastrophic printed circuit board damage in the case of gross AC line input overloads.
Window Heat Control Proportionally controlled closed loop window heater drive circuit with outside temperature sensor unit to provide fog free window operation under all environmental conditions. SW720A WTI ~ Page 24 of 27...
“OFF” within that zone. Low Pressure Warning Provides low pressure warning indicator on video display for cameras supplied with pressurized camera housing option. Temperature Warning Provides an internal temperature warning indication on the video display. SW720A WTI ~ Page 25 of 27...
EIA RS-485 signal levels and drive capabilities. Data Transient Protection Gas discharge tubes followed by 40A 300W transient voltage suppressors. Control Data Protocol Cohu, Pelco D, WTI, NTCIP, ONVIF and others. Power interrupt immunity NEMA TS-2 paragraph 2.1.4. Power transient immunity NEMA TS-2 paragraph 2.1.6.
White powder coated aluminum and Kydex 550 with all stainless steel hardware REVISION HISTORY 10/22/14 – Initial release of SW720A 120VAC camera series installation manual. Several other manuals covering different models also released. 11/19/14 – Addition of additional mounting options 12/17/14 –...
Need help?
Do you have a question about the SW720A and is the answer not in the manual?
Questions and answers