Installation; Introduction; Unpacking And Inspection; Warranty - AEM SM10 Installation And Operation Manual

2.1

Introduction

Information in this section consists of: unpacking and inspection procedures, installation procedures,
post-installation checks, and installation drawings.
2.2

Unpacking and Inspection

Unpack the equipment carefully. Inspect the unit visually for damage due to shipping and report all such
claims immediately to the carrier involved. Note that each unit should have the following:
- AA31 ICS Mode Controller
- Product Information Card
- Release certification
Verify that all items are present before proceeding and report any shortage immediately to your supplier.
2.2.1

Warranty

All Anodyne Electronics Manufacturing Corp. (AEM) products are warranted for 2 years. See the website
www.aem-corp.com/warranty for complete details.
2.3

Installation Procedures

2.3.1

Warnings

Do not bundle any lines from this unit with transmitter coax lines. Do not bundle any logic, audio, or DC
power lines from this unit with 400 Hz synchro wiring or AC power lines. Do not position this unit next to
any device with a strong alternating magnetic field such as an inverter, or significant audio interference
will result.
2.3.2

Cautions

In all installations, use shielded cable exactly as shown and ground as indicated. Significant problems
may result from not following these guidelines.
2.3.3

Cabling and Wiring

All unshielded wire shall be selected in accordance with AC43.13-1B Change 1, Paragraphs 11-76
through 11-78. Wire types should be to MIL-W-22759 as specified in AC43.13-1B Change 1, Paragraphs
11-85, 11-86, and listed in Table 11-11. For shielded wire applications, use Tefzel MIL-C-27500 shielded
wire with solder sleeves (for shield terminations) to make the most compact and easily terminated
interconnect. Follow the wiring diagrams in Section 2.6 as required.
April 14, 2012 Rev: 5.00
ENG-FORM: 805-0100.DOTX
CONFIDENTIAL AND PROPRIETARY TO ANODYNE ELECTRONICS MANUFACTURING CORP.
AA31 ICS Mode Controller
SM10 Installation and Operation Manual
Section 2.0 Installation
Page 2-1