Table of Contents
Advertisement
10. Using the vacuum pen 1 , remove the microprocessor from the system board
socket by lifting it straight up and out of the socket.
Important
Do not touch the gold contacts on the bottom of the microprocessor. If
you must touch the microprocessor, touch only the sides.
Notes:
a. Note the orientation of the notches 1 on the microprocessor. This is
important when reinstalling the microprocessor on the new system board.
b. Do not drop anything onto the microprocessor socket while it is exposed.
The socket pins must be kept as clean as possible.
Chapter 2. Replacing hardware
11
Advertisement
Table of Contents
