Lenovo ThinkCentre 7515 Hardware Maintenance Manual page 63

Diagnostic error code
000-039-XXX
BIOS DMI data error
000-195-XXX
BIOS Test aborted by user
000-196-XXX
BIOS test halt, error threshold exceeded
000-197-XXX
BIOS test warning
000-198-XXX
BIOS test aborted
000-199-XXX
BIOS test failed, cause unknown
000-250-XXX
BIOS APM failure
000-270-XXX
BIOS ACPI failure
001-000-XXX
System Test Passed
001-00X-XXX
System Error
001-01X-XXX
System Error
001-024-XXX
System Addressing test failure
FRU/Action
1. Flash the system. See "Updating
(flashing) BIOS from a disc" on page
278
2. System board
Information only
Re-start the test, if necessary
1. Press F3 to review the log file
2. Re-start the test to reset the log file
1. Make sure the component that is called
out is connected and/or enabled. See
Chapter 6, "Using the Setup Utility
program," on page 51
2. Re-run test
3. Replace the component that is called out
in warning statement
4. Replace the component under test
1. Make sure the component that is called
out is connected and/or enabled. See
Chapter 6, "Using the Setup Utility
program," on page 51
2. Flash the system and retest. See
"Updating (flashing) BIOS from a disc"
on page 278
3. Go to "Undetermined problems" on page
81
1. Go to "Undetermined problems" on page
81
2. Flash the system and re-test
3. Replace component under function test
1. Flash the system. See "Updating
(flashing) BIOS from a disc" on page
278
2. System board
1. Flash the system. See "Updating
(flashing) BIOS from a disc" on page
278
2. System board
No action
System board
System board
System board
Chapter 7. Symptom-to-FRU index
57