Replacing The Microprocessor - Lenovo THINKCENTRE 5068 Hardware Maintenance Manual

Machine types: 5068, 7558, and 7567
Hide thumbs Also See for THINKCENTRE 5068:
Table of Contents

Advertisement

9. Follow the sequence
sink assembly to the system board, as shown in Figure 27 "Loosing the four screws that secure the heat
sink assembly to the system board" on page 106.
10. Reinstall the system board shield. See "Removing and reinstalling the system board shield" on page 102.
11. Go to "Completing the parts replacement" on page 125.

Replacing the microprocessor

Attention
Do not open your computer or attempt any repair before reading and understanding the "Important safety
information" in the ThinkCentre Edge Safety and Warranty Guide that came with your computer. To obtain a
copy of the ThinkCentre Edge Safety and Warranty Guide, go to:
http://www.lenovo.com/support
This section provides instructions on how to replace the microprocessor.
CAUTION:
The heat sink and fan assembly might be very hot. Turn off the computer and wait three to five
minutes to let the computer cool before removing the computer cover.
To replace the microprocessor, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Place a soft, clean towel or cloth on the desk or other flat surface. Hold the sides of your computer and
gently lay it down so that the screen is against the surface and the cover is facing up.
3. Remove the computer cover. See "Removing the computer cover" on page 95.
4. Locate the microprocessor on the system board. See "FRU locations" on page 86.
5. Remove the system board shield. See "Removing and reinstalling the system board shield" on page 102.
6. Remove the heat sink assembly to gain access to the microprocessor. See "Replacing the heat sink
assembly" on page 105.
7. Press the small handle
1
,
2
,
3
,
4
on the heat sink assembly to tighten the four screws to secure the heat
1
to open the retainer
2
to access the microprocessor
3
.
.
Chapter 8
Replacing FRUs
107

Advertisement

Table of Contents
loading

Table of Contents