Lenovo ThinkCentre 3379 User Manual page 30

Installing a drive in bay 2
This section provides instructions on how to install a drive in bay 2.
To install an optical drive or an additional hard disk drive in bay 2:
1. Open the computer cover. See "Opening the computer cover" on page 14.
2. If there is a metal static shield installed in the drive bay, remove the metal
3. If you are installing a drive with accessible media, such as an optical drive,
4. Install the retainer that comes with your drive on the side of the drive.
Figure 13. Installing the retainer
22
User Guide
Attention
Do not open your computer or attempt any repair before reading and understanding the
"Important safety information" in the ThinkCentre Safety and Warranty Guide that came with
your computer. To obtain a copy of the ThinkCentre Safety and Warranty Guide, go to:
http://www.lenovo.com/support
shield by using a flat-blade screwdriver to gently pry it loose.
remove the plastic panel in the bezel by squeezing the plastic tabs that secure
the panel on the inside of the bezel.
Note: If you are installing a 3.5-inch hard disk drive, you must use a Universal
Adapter Bracket, 5.25 to 3.5-inch. You can obtain this bracket from a local
computer retailer or by contacting the Customer Support Center.