Table of Contents
Advertisement
m
MECHANISM
REMOVAL (CD)
.—
4)
(1)
1)
2)
Check
points
for
CD
mechanism
assembly
and
lubrication
Lubricating
and mounting
the tray slide
Apply grease
(FLOIL
G-4748)
to the area indicated
by the
diagonal
in the figure.
When inserting the tray slide (CM1 5), set the position
where it is installed vis-a-vis the base/tray
timing gear
(CM20) as shown in the figure.
y
P
BASE / TRAY
v
I
TIMING
GEAR (CM20)
(3)
1)
2)
3)
4)
(2)
1)
2)
3)
Installing the tray gear
Move the tray slide (CM I 5) in the direction of the arrow
0.
Engage the gear section of the tray slide (CM15) with the
inner gear of the tray gear (CM6) at the center line, as
shown in the figure.
Align the tray move gear (CM3) with the position
(0)
of
the hole in the outer gear of the tray gear (CM6),
and
engage the tray move gear (CM3), as shown in the figure.
TRAY
SLIDE
CM6
Installing the base up/down slide and timing gear
Move the base up/down slide (CM14)
in the direction of
the arrow @, and set the gears at the positions shown in
the figure.
Insert the timing gear (CM23),
and mount it using the
screw (CM21 ).
Turn the timing gear (CM23) counterclockwise.
TIMING
GEAR
BASE UP/ DOWN
@JF~:~4
\
v
SCREW
(CM21)
@
Hook the gear tension spring (CM22) onto the timing gear
(CM23).
msH'oN
-8-
Advertisement
Table of Contents
