Diagnostic Mode - iStorage Datashure SSD User Manual

SSD

20. Diagnostic Mode

The keypad has a manual diagnostic mode built-in to verify keypad function. This mode will not allow access to any data or
admin function. It can only be used to identify the firmware level and to test button recognition.
To enter the diagnostic function:
1. Press UNLOCK, then press
BLUE LED's will blink alternately.
2. The BLUE LED will blink a number of times to represent the number of both the major and minor revisions. The decimal
point will be represented by a single
VERSION 4.1 would be indicated by four
LED blink, then revert to a solid
3. To check the keypad's button functionality:
Press each button and the number of the button pressed will be expressed by the
= 1 blink, 2 Button = 2 blinks, 3 Button = 3 blinks...0 Button = 10 blinks, Unlock Button = 11 blinks, Lock Button = 12
blinks.)
4. To exit the Diagnostic Mode, wait for the 20 second timeout to return the datAshur SSD to normal operation.
Self-Diagnostics:
During the initial power up, after the datAshur SSD has been plugged into a USB port, the datAshur SSD will perform
self-diagnostics on the encryption algorithm and critical hardware components. If the
per second for 15 seconds, returns to standby and will not unlock, unplug the datAshur SSD from USB port and try again.
If the RED LED continues to blink in the manner mentioned above and won't unlock upon USB re-insertion, a critical
component has failed and the datAshur SSD can no longer function.
If the datAshur SSD blinks a
that will not immediately stop the device from working nor affect the security of the device, but should be considered as a
warning that the device needs to be replaced in the near future. Additionally, Admin features may be limited in this mode.
If either condition should appear, remove the datAshur SSD from the USB port and allow the datAshur SSD to go to sleep,
and try to unlock the datAshur SSD again.
The event of either diagnostic failure will be very rare, but if the datAshur SSD cannot recover, it must be replaced.
#16 #16
UNLOCK + the number 1 button, then press and hold 0 for five seconds. The
RED
LED blink. Upon completion, the
BLUE LED blinks, one
BLUE LED.)
triple-RED LED pattern that is repeated every two seconds when unlocked, a failure has occurred
www.istorage-uk.com www.istorage-uk.com
BLUE
LED will be solid. (Example:
RED LED blink, one BLUE
RED LED blinking. (Example: 1 Button
RED
LED blinks at a rate of one blink
RED and
LED blink, and one RED