Xsential X-301 Installation & Operating Manual

X S E
X S E

1.0 Components:

When you purchase the Diana Instant Hot Water tank, contents
include:
1. X-301 boiler
2. DLX-580 faucet
3. Feed water shut-off valve
4. Feed water adapter
5. ¼" feed water tube

2.0 Material required (Not provided)

►ruler or measuring tape
►35mm drill bit - if no sink hole exists
►small drill bit for starter holes
►hand or electric drill

3.0 Faucet Compatibility

Only "Open Vent" faucets function with an instant hot water dispenser tank. Connecting a standard
faucet will damage the tank and void the warranty.

IMPORTANT INFORMATION

This hot water dispenser produces instant hot water of approximately 98°C (208°F) as dispensed
from the faucet. This product is not intended to produce a continuous flow of hot water. The
standard model will produce up to 60 cups of water per hour at approximately 98°C (208°F). Due to
high water temperature, for safety reasons, the tank is not under pressure. Consequently, there is a
slight delay of water flow after the faucet has been turned on. This is normal and indicates that the
priming chamber is functioning properly.
•
Do not extend the hot water outlet tube.
•
Minimum working pressure: 220kPa (system might not work properly if the pressure is below the
requirement).
When using all electrical appliances, basic safety precautions should always be followed including the
following:
N T I A L X - 3 0 1 I N S T
N T I A L X - 3 0 1 I N S T
I
I
N N S S T T A A L L L L A A
►open-end wrench
►tubing cutter
►pliers

IMPORTANT SAFETY INSTRUCTIONS

PLEASE READ ALL INSTRUCTIONS CAREFULLY
A N T H O T W A T E
A N T H O T W A T E
& O
& O
T T I I O O N N P P E E R R A A T T I I N N G G
R D I S P E N S E R
R D I S P E N S E R
G
G
U U I I D D E E
►gloves
►safety glasses
►bucket or pan