Registering An Additional Handset; To Register A Handset; Notes - VTech LS6001A Quick Start Manual

Registering an Additional Handset

The LS6001A additional handset must be registered to the LS6191A telephone base before use. When first
purchased, each expansion handset alternately shows To register HS... and ...see manual. The new handset should
be charged without interruption for at least 30 minutes before registering it to the telephone base. To register the
additional handset to your LS6191A, follow the instructions below.

To register a handset:

. At the bottom of the telephone base, press and hold PAGE for about four seconds
until it shows Registering...
. On the cordless handset, press # then it shows Registering... Both the telephone
base and cordless handset show Registered and you hear a beep when the
registration process completes. The registration process takes about 60 seconds
to complete.
If registration fails, the handset displays Failed. Please start again from Step  above.

NOTES

• You cannot register a handset if any other system handset is in use.
• If you have not set the date and time for the telephone system, the handset will prompt you to set the
date and time after it is registered to the base. To skip setting, press CANCEL.
If you have any difficulty with the operations of LS6001A handset or LS6191A base station, refer to your
LS6191A User's manual.
For technical support, please call VTech Technical Inquiry Hotline.
© 05 VTech Telecommunications Ltd. All Rights Reserved.