TABLE OF CONTENTS WARRANTY SPECIFICATIONS INTRODUCTION INSPECTION AND ACCESSORIES 4.1 External inspection 4.2 Unpacking 4.3 Accessories ……… 6 BATTERY OPERATION ……… 7 5.1 Battery installation 5.2 Battery life FRONT PANEL CONTROLS AND DISPLAYS MA1 CONNECTIONS AUDIOMETRIC TESTING 8.1 Instructing the patient 8.2 Test environment 8.3 Conducting the test PREVENTATIVE MAINTENANCE...
Page 3
Place the audiometer in the original shipping carton using the foam supports supplied. Insure properly and return it to your Maico distributor. Note: Warranty services will be provided by the authorized distributor from whom you purchased the audiometer.
Maico distributors are located in major cities throughout WARRANTY the world. To minimize shipping charges and delay, contact Maico for the location of the distributor nearest to you. Maico Limited One Year Warranty You can contact Maico at: This warranty is extended to the original purchaser of the...
If repair and recalibration is Calibration: Calibrated to ANSI S3.6-1996 needed, be sure the work is done by a Maico Special Instrument Service Center. This assures the use of quality materials by trained and experienced technicians using...
Page 6
PREVENTATIVE MAINTENANCE Electrical To maximize the service life of your audiometer and Power Requirements: 2 AA Alkaline batteries headset we suggest the following: Battery Life: Stand by: ~6 months Tone presentations: 30,000 for 2 sec 1. Dust the audiometer occasionally with a soft, dry cloth. duration &...
(i.e .5, 1, 2, or 4 kHZ) is held down. If the patient does not respond to Maico audiometers have been designed to meet the most the tone, increase the tone by 5dB using the up thorough of electrical safety standards and to provide years arrow key and present again.
Save all packing material so the claim adjuster can supplementary attenuation to noise. These can be inspect it as well. Notify Maico as soon as the used instead of, or in addition to, a sound room. adjuster has completed the inspection.
If any accessories are missing or damaged, immediately Place the subject at ease concerning the test. notify your Maico Special Instrument Distributor, Explain the purpose of the test and what kind of from whom the instrument was purchased.
MA1 CONNECTIONS BATTERY OPERATION Battery Installation Figure 3 Figure 1 1. Earphone Jack Plug Battery compartment – back view To install the batteries: 1. Pull the tab on the battery compartment and remove panel. 2. Insert 2 AA batteries in the compartment 3.
Maico recommends using 2 AA Alkaline batteries. Batteries will last approximately 30,000 tone presentations. The MA 1 has an automatic shut-off feature to prolong battery life when unit is not in use. When batteries get too low to produce the proper signal, the unit will shut off and will not turn back on until batteries are replaced.
Need help?
Do you have a question about the MA 1 and is the answer not in the manual?
Questions and answers