Safety Instructions; Safety Precautions; Product Safety Notice; Service Personnel Warning - Sanyo PLC-SW20A Service Manual

■ Safety Instructions

■ SAFETY PRECAUTIONS

WARNING:
The chassis of this projector is isolated (COLD) from AC line by using the converter transformer. Primary side of
the converter and lamp power supply unit circuit is connected to the AC line and it is hot, which hot circuit is iden-
tified with the line (
injury, servicing should be made with qualified personnel.
The following precautions must be observed.
1: An isolation transformer should be connected in the power line between the projector and the AC line before any
service is performed on the projector.
2: Comply with all caution and safety-related notes provided on the cabinet back, cabinet bottom, inside the cabi-
net or on the chassis.
3: When replacing a chassis in the cabinet, always be certain that all the protective devices are installed proper-
ly, such as, control knobs, adjustment covers or shields, barriers, etc.
DO NOT OPERATE THIS PROJECTOR WITHOUT THE PROTECTIVE SHIELD IN POSITION AND PROPER-
LY SECURED.
4: Before replacing the cabinet cover, thoroughly inspect the inside of the cabinet to see that no stray parts or
tools have been left inside.
Before returning any projector to the customer, the service personnel must be sure it is completely safe to oper-
ate without danger of electric shock.

■ PRODUCT SAFETY NOTICE

Product safety should be considered when a component replacement is made in any area of the projector.
Components indicated by mark
safety can be of special significance. It is, therefore, particularly recommended that the replacement of the parts
must be made by exactly the same parts.

■ SERVICE PERSONNEL WARNING

Eye damage may result from directly viewing the light produced by the Lamp used in this equipment. Always turn
off Lamp before opening cover. The Ultraviolet radiation eye protection is required during this servicing.
Never turn the power on without the lamp to avoid electric-shock or damage of the devices since the stabilizer
generates high voltages(20~25kV) at its starts.
Since the lamp is very high temperature during units operation. Replacement of the lamp should be done at least
45 minutes after the power has been turned off, to allow the lamp cool-off.

■ REMOTE CONTROL BATTERY INSTALLATION

1
Pull out Battery Holder.
To insure safe operation, please observe the following precautions :
● Do not expose a battery to moisture or heat. Do not charge a battery.
● If a battery have leaked on Remote Cotrol Unit, carefully wipe the case clean and load a new battery.
● Be sure to install battery with correct polarity.
Risk of explosion if battery is replaced by an incorrect type.
Dispose of used batteries according to the instructions.
) in the schematic diagram. For continued product safety and protection of personnel
in the parts list and the schematic diagram designate components in which
Replace with new battery. Install
2
with battery (+),(–) marks properly.
Put Battery + mark
as shown direction.
BATTERY HOLDER
CAUTION
Install battery and
3
Battery Holder into
Remote Control Unit.
BATTERY
LITHIUM BATTERY
CR2025 (3.0V)
(+) mark indicates
its (+) polarity.
-3-