Adjustment - Sanyo PLC-SW20A Service Manual

■ Adjustment

■ SERVICE ADJUSTMENT MENU OPERATION
■ To enter service mode
To enter service mode press the "MENU" and "IMAGE"
buttons on the projector simultaneously and hold for 2
seconds. As shown in a figure, a service mode display
appears on a screen.
■ Adjustment
Adjust service data using the following control buttons.
1. "POINT UP" -------
2. "POINT DOWN" --
3. "POINT RIGHT" --
"VOLUME+"
4. "POINT LEFT" ----
"VOLUME - "
■ To exit service mode
Press the "POWER on/off" button only once on the projec-
tor or remote control unit to quit the service mode.
■ LOCATION OF TEST POINT AND VR
TEST POINTS LOCATION
ASSY PWB MAIN
An item number increases.
An item number decreases.
An adjustment value increases.
An adjustment value decreases.
Normal Mode
Service Mode
"Point Up / Down"
Adjustment item
TP-66A
TP-R1
TP-G1
TP-STG1
TP-B1
VR5601
-11-
Service Mode
"MENU"
"IMAGE"
Service Mode
Computer
10
"POWER
ON/OFF"
Computer
10 137
"Point Left / Right"
"Volume + / -"
Adjustment deta value
137