Chevrolet Aveo Owner's Manual page 225

TPMS sensor matching process
Each TPMS sensor has a unique
identification code. The identification
code needs to be matched to a new
tyre/wheel position after rotating the
tyres or replacing one or more of the
TPMS sensors. The TPMS sensor
matching process should also be
performed after replacing a spare tyre
with a road tyre containing the TPMS
sensor. A should go off at the next
ignition cycle. The sensors are
matched to the tyre/ wheel positions,
using a TPMS relearn tool, in the
following order: left front tyre, right
front tyre, right rear tyre and left rear
tyre. See your Chevrolet authorised
repairer for service or to purchase a
relearn tool.
The first tyre/wheel position should be
matched within two minutes, and all
four tyre/wheel positions should be
matched within five minutes. If it takes
longer, the matching process stops
and must be restarted.
The TPMS sensor matching process
is as follows:
1. Apply the parking brake.
2. Turn the ignition to ON/RUN with
the engine off.
3. Use the MENU button in the turn
signal to select the menu in the
Driver Information Centre (DIC).
4. Use the thumbwheel to scroll to
the Tire Learn menu item screen.
5. Press the SET/CLR button to
begin the sensor matching
process. A message requesting
acceptance of the process should
display.
6. Press the SET/CLR button again
to confirm the selection. The horn
sounds twice to signal the
receiver is in relearn mode.
Vehicle care
7. Start with the left front tyre.
8. Place the relearn tool against the
tyre sidewall, near the valve stem.
Then press the button to activate
the TPMS sensor. A horn chirp
confirms that the sensor
identification code has been
matched to this tyre and wheel
position.
9. Proceed to the right front tyre, and
repeat the procedure in Step 8.
10. Proceed to the right rear tyre, and
repeat the procedure in Step 8.
11. Proceed to the left rear tyre, and
repeat the procedure in Step 8.
The horn sounds twice to indicate
the sensor identification code has
been matched to the left rear tyre,
and the TPMS sensor matching
process is no longer active.
12. Turn the ignition to LOCK/OFF.
13. Set all four tyres to the
recommended air pressure level
as indicated on the Tyre and
Loading Information label
223