Fault Finding Chart; Replacement Parts; Environmental Information - Flymo SAMURAI 1000XT Original Instructions Manual

Cable Storage
1. Your mains cable can be stored on the product as
illustrated in Fig Z1.
2. Wind cable carefully to avoid kinking.
3. To release the cable press the button and the hook
will drop down (Z2).
4. Push cable hook fully back into position.
Hexagon Drive Tool Storage
1. Your Hexagon Drive Tool can be stored in the
Handle Clamp as illustrated in Fig Z3.
Z3
WARNING Disconnect from the mains electricity supply before attempting any maintenance or adjustment.
FAULT
LINE NOT FEEDING
OR
LINE TOO SHORT
OR
TRIMMER VIBRATES
CONTINUOUS
CLATTERING NOISE
LINE SNAPS
CONTINUOUSLY
IF NONE OF THE ABOVE
OR IF FAULT PERSISTS
Spool and Line
Reference no.:
• Awareness of the environment must be
considered when disposing of 'end-of-life' product.
• If necessary, contact your local authority for
disposal information.
The symbol on the product or on its packaging
indicates that this product may not be treated as
household waste. Instead it shall be handed over to
the applicable collection point for the recycling of

Fault Finding Chart

Is the line fed out and visible?
Has line been removed from
cleat?
Is the automatic line feed work-
ing?
Has the motor reached full speed
before use?
Has too much line been fed out?
Is the line cutter missing from the
safety guard?
Are you using the product
correctly?
Is the line jamming on the spool?
Contact Husqvarna UK Ltd. Customer Service
Telephone : 0844 844 4558 UK

Replacement Parts

FLY057

Environmental Information

Z1
Z2
CHECK
Part no.:
electrical and electronic equipment. By ensuring this
product is disposed of correctly, you will help prevent
potential negative consequences for the environment
and human health, which could otherwise be caused by
inappropriate waste handling of this product. For more
detailed information about recycling of this product,
please contact your local council office, your household
waste disposal service or the shop where you
purchased the product.
ACTION
Remove cap and spool, free line
No
and re-fit spool and cap. SEE
"CUTTING HEAD"
The line may be jammed on the
spool. Rewind line to remove
No
crossed loops. Check that line is in
correct section of spool.
Allow the motor to reach full speed
No
before use.
Yes
Rewind line
Contact your local approved Serv-
Yes
ice Centre or Husqvarna UK Ltd.
Customer Service.
Only use tip of nylon line to trim.
?
SEE "Use"
Rewind the line on the spool, if
Yes
symptoms still persist, change
spool and line.
1800 882 350 ROI
510778990