Replacing The Mouse - Lenovo IDEACENTRE B3 Hardware Replacement Manual

Replacing the mouse

Attention:
Do not remove the computer cover or attempt any repairs before reading
the "Important safety information" in the Safety and Warranty Guide that was
included with your computer or in the Hardware Maintenance Manual (HMM)
for the computer. To obtain copies of the Safety and Warranty Guide or
HMM, go to the Support Web site at: http://consumersupport.lenovo.com
To replace the mouse:
1. Remove any media (disks, CDs, or memory cards) from the drives, shut down
the operating system, and turn off the computer and all attached devices.
2. Unplug all power cords from electrical outlets.
3. Locate the connector for the mouse. Refer to "Left and right view" and "Rear
view".
Note: Your mouse will be connected to the USB connector at either side or at
the rear of the computer.
4. Disconnect the defective mouse cable from the computer and connect the
new mouse cable to the same connector.
31048859 IC B3 HRG V2.0 (EN)(R).indd 19
Hardware Replacement Guide
2011-1-19 18:02:32
19