Manual Image Setup - Lenovo ThinkVision L190 User Manual

Manual Image setup

i
If the monitor is in standby
mode, it might automatically
turn off while you are waiting
for it to warm up.
Normally, you can complete the setup procedure using Automatic Image setup
however, if your screen image is still distorted after you perform Image setup or
the setup CD does not run on your system, perform M
To manually adjust the image setting, do the following:
1. Turn on the monitor and wait approximately 15 minutes for it to warm
up.
2. Display the image you most frequently use on the screen.
3. Press the OSD Enter button "
the initial OSD menu.
4. Use the Right Arrow button "
and press the OSD Enter button "
5. Use the Right Arrow button "
button " " twice to select clock.
6. Use the Arrow buttons to manually adjust to correct for jitter or noise in
the image. Press the OK button "
7. Press OK " " and use the Arrow buttons to adjust phase, then press
OK " ".
Press OK " " again to save and exit. Then press Exit button "
twice to exit OSD.
You have completed the monitor setup.
anual
" at the bottom of the monitor to display
" to select the Image setup icon "
" to access the function.
", to select manual. Press the OK
".
;
Image setup.
"
"
17