Playing A Tape; Recording On A Tape - Sony CFD-CD777SMK2 Service Manual

QQ
3 7 63 1515 0

Playing a tape

3
1
2
3
TE
L 13942296513
GB
8

Recording on a tape

1
2
www
.
GB
10
http://www.xiaoyu163.com
1 2 3 2
For hookup instructions, see pages 19 — 20.
Set FUNCTION to TAPE¥CD/
RADIO OFF.
Press xZ to open tape compartment
and insert a recorded tape. Use TYPE
I (normal) tape only. Close the
compartment.
With the side you want
to play facing you
Press PLAY N.
The player starts playing.
2 3 1
MIC
Press xZ to open the tape
compartment on deck B and insert a
blank tape. Use TYPE I (normal)
tape only. Close the compartment.
With the side you want to
record on facing you
Select the program source you want
to record. Display
To record from the CD player, set
FUNCTION to CD and insert a CD.
To record from the radio, set
FUNCTION to RADIO, and tune in
the station you want using BAND
x ao
y
and TUNING.
To record from the built-in
i
microphone (MIC), set FUNCTION
to TAPE¥CD/RADIO OFF.
http://www.xiaoyu163.com
8
Note
During playback, do not
press M, m or N on
the other deck as this causes
excessive wow and flutter.
Tips
¥ During operation, the level
meter shows the frequency
level of the sound.
Adjusting the volume will
not affect the level meter.
¥ To play tapes in both decks
successively, press N on
deck B and then press
PLAY and X on deck A as
the same time. When the
tape ends on deck B, the
playback starts
automatically on deck A.
Q Q
3 6 7 1 3
3
Deck B
Notes
¥ During recording, do not
press M, m or PLAY
on deck A as this causes
excessive wow and flutter.
¥ While recording from the
built-in microphone (MIC),
no sound comes from the
speakers or the headphones.
¥ When you connect the
microphone to the MIX
MIC jack, you cannot
record from the built-in
microphone.
Tips
¥ Adjusting the volume or
selecting the audio
emphasis will not
affect the recording
level.
¥ If the MW program makes
a whistling sound after
you've pressed z in step 3,
set the ISS¥FM MODE
(Interference Suppress
Switch) at the rear to the
position that most decreases
the noise.
¥ For the best results, use the
AC power as a power
u163
source.
¥ To erase a recording,
proceed as follows:
1 Insert the tape into deck
.
B.
2 Disconnect the audio
source if connected to the
TV/LINE IN jack at the
rear.
3 Set FUNCTION to TV/
LINE IN.
4 Press z on deck B.
CFD-CD777SMK2
2 9 9 4 2 8
Use these buttons for additional operations
DIRECTION
DIR MODE Level meter
h H
VOLUME
To Do this
adjust the volume Turn VOLUME.
stop playback Press xZ.
Press m or M.
fast-forward or rewind the tape
pause playback Press X.
Press the button again to
resume play after pause.
play the opposite side of Press down DIRECTION
the tape (deck A only) once.
DIRECTION h H (reverse/
forward) indicators show the
tape direction of deck A.
Press xZ.
eject the cassette
To select the direction of the tape (deck A
only)
To play Set DIR MODE to
both sides of the tape
repeatedly
both sides of the tape
from the front side to
reverse side only*
1 5 0 5 8 2 9 9 4
* If play begins from the reverse side, the tape stops at the end of
that side.
Start recording.
Press z on deck B (N is depressed
automatically).
Use these buttons for additional operations
xZ
To Press
stop recording xZ on deck B
pause recording X on deck B
Press the button again to resume
recording.
m
co
9 9
m, M
xZ
X
m, M
X
xZ
2 8 9 9
GB
9
X
n
xZ
X
GB
11
5