Beat BEAT490 Instruction Manual page 8

8. DAB / DAB+ Operation
Digital Audio Broadcasting (DAB), is a way of broadcasting radio
digitally through a network of transmitters. It provides you with more
choice, better sound quality, and more information.
NOTE
If there is no DAB coverage currently available, or DAB signal is too
weak in your area, no DAB station could be found, and the below
message will be displayed: "NO STATION AVAILABLE".
Installation the DAB antenna
CAUTION
Make sure the antenna cable does not interfere with the safe operation
of driving wheel, air bags and seatbelts or other equipment.
Before entering low overhangs, car washes, or other places with
obstacles which may catch on or touch the antenna, remove the
antenna to avoid potential damage.
Damage caused by not following the installation instructions is not
covered by warranty.
DAB / DAB+ Antenna
DAB / DAB+ Antenna
1. Find a location as flat as possible on the outside of your car. For
example, the roof near the windshield, or rear window.
NOTE
The magnetic base of the antenna will remain secure at normal
vehicle speeds in non-windy conditions. Antennae installed on
curved surfaces may become detached in windy conditions.
2. Make sure the selected surface is clean and free of dirt, water, or
othersubstances which could inhibit attachment to the surface.
3. Gently place the magnetic steel base of the DAB/DAB+ antenna on
the surface you selected. The magnetic steel base will stick to any
metallic surface.
WARNING
Damage may be caused to the paintwork of the car if the antenna
slides or rotates on the car surface.
4. Route the cable: Tuck the cable under weather strip of the door and
run the cable through the passenger doorway or tailgate. Reserve
enough slack in your cable to fit open doors or deck lids. Secure
cables to avoid cable being pinched between hinges and the door.
E - 8