Cateye Velo 9 User Manual page 2

How to install the unit on your bicycle
Sensor
Double-sided tape
Bracket Wire
1
2
Install the sensor and magnet
The magnet passes through the The clearance between the sen-
sensor zone. sor and magnet is 5 mm (3/16")
or less.
Magnet Magnet
Sensor
Magnet Magnet
SENSOR ZONE
1
Attach the bracket to the stem or handlebar
The FlexTight™ bracket can be attached to either the stem or the handlebar, depending on how the bracket fi ts into the
Magnet
bracket band.
When attaching the FlexTight™ bracket to the stem
Nylon ties
(x 7)
When attaching the FlexTight™ bracket to the handlebar
2
Install the sensor and magnet
Spoke
Magnet Magnet
To the
SENSOR ZONE
* The magnet may be in-
stalled anywhere on the
spoke if the above instal-
lation conditions are satis-
fi ed.
Sensor
Sensor
(3/16")
Nylon ties Nylon ties Bracket
Bracket
Double-sided tape
Bracket
Nylon ties Nylon ties
Bracket
Double-sided tape
Sensor
SENSOR
ZONE
Magnet
Cut
Pull
securely
Nylon ties
VELO 9 / VELO 7
Stem
Cut
Nylon ties
Pull securely
While supporting it by hand,
Handlebar Nylon ties Nylon ties
Cut
Push it out as if lifting
Pull securely the front up
3
Route the wire
OK
NO!
Nylon ties
Caution:
Adjust the wire length so that it may not be pulled when the
handle is operated.
ENG 2
Remove/Install
the computer
Click