Advertisement
LOOSE LEAF STEPS cont.
Inhalation
The quicker the draw, the cooler the chamber will become,
while a slower draw will warm up the chamber; each user will
find their own preference. After each inhalation release the
switch to not overheat the material or the device, this will also
increase battery life. After the first initial warm up, the device
will retain the heat, back to back inhalations will not require a
warm up each time. It is recommended for the user to try differ-
ent inhaling techniques, as some may work well for some
users, while other techniques will not.
Reloading
When the vapor production tapers off, it will indicate
that most of the material has been vaporized.
Remove top cap to discard material (you will notice a
change in color), reload material as mentioned in
"Loading Material"
Checking Material
Checking Material
Pull the Top Cap off at anytime to check the progress. Over
Pull the Top Cap off at anytime to check the progress. Over
time the center part of the material will shift from green to
time the center part of the material will shift from green to
brown as vaping progresses. The darker area will naturally
brown as vaping progresses. The darker area will naturally
spread to all of the material, no stirring is normally needed
spread to all of the material, no stirring is normally needed
but can be done. Most users stop vaping when production
but can be done. Most users stop vaping when production
tapers off, or a 'burnt popcorn taste' appears. When these
symptoms occur, check material and reload if needed.
*Caution: Using the Cera
for an extended amount of
time can make the device
hot to the touch.
Advertisement
