Lincoln Electric 2004 Town Car Owner's Manual page 131

Locks and Security
2. Do not wipe off any grease on the
battery terminals on the back
surface of the circuit board.
3. Remove the old battery.
4. Insert the new battery. Refer to the diagram inside the remote entry
transmitter for the correct orientation of the battery. Press the battery
down to ensure that the battery is fully seated in the battery housing cavity.
5. Snap the two halves back together.
Note: Replacement of the battery will not cause the remote transmitter
to become deprogrammed from your vehicle. The remote transmitter
should operate normally after battery replacement.
Replacing lost remote entry transmitters
If you would like to have your remote entry transmitter reprogrammed
because you lost one, or would like to buy additional remote entry
transmitters, you can either reprogram them yourself, or take all
remote entry transmitters to your authorized dealer for
reprogramming.
How to reprogram your remote entry transmitters
You must have all remote entry transmitters (maximum of four)
available before beginning this procedure.
To reprogram the remote entry
4
transmitters:
3
1. Ensure the vehicle is
5
electronically unlocked.
2
2. Put the key in the ignition.
3. Turn the key from the 2 (LOCK)
position to 3 (OFF).
1
4. Cycle eight times rapidly (within
10 seconds) between the 3 (OFF) position and 4 (ON). Note: The
eighth turn must end in the 4 (ON) position.
131
2004 Town Car (tow)
Owners Guide (post-2002-fmt)
USA English (fus)