Advertisement
Factory default is set to level 3.
Under Brightness auto change mode, press any button or IR remote control, or video signal
changed (video signal disappears or show up), LED status will show the maximum
brightness up to 5 seconds then back to the minimum brightness.
Computer Remote Control Function:
This console could use optional USB、 、 、 、 RS-232 and RS-485 terminal cable to connect with
computer, To use terminal program for remote control operation, the communication format
is 9600,8,N,1 (9600 Bps, 1 start bits, 8 data bits, 1 stop bit).
Under remote control operation, If it shows 「 「 「 「 COMMAND」 」 」 」 , then it is "under command mode".
It could easily be operated and set by entering the following commands in the chart.
Press 「 「 「 「 Enter」 」 」 」 : if it shows 「 「 「 「 OK!」 」 」 」 then the previous command is completed; showing 「 「 「 「 ERROR!」 」 」 」
indicates the previous command is incorrect.
Command Mode Instruction:
[COMMAND]
------------------------- -------------------------------------------
n
PRE
NEXT
SCAN y
JUMP y
ACTIVATE
STANDBY
MODE x
IR y
KEY y
LED n
SAVE
LOAD
KEYPAD
SIGNAL
STATUS
VERSION
?
[SYMBOL]
------------------------- -------------------------------------------
n
x
y
Space characters between the command and parameters can be ignored.
Virtual Remote Control Mode:
Showing 「KEYPAD :」 when it is under virtual remote control mode, which you could enter
the following commands at the terminal to simulate the IR remote control operation.
After press command if it shows 「OK!」 then the previous command is executed; showing
「ERROR!」 indicates the previous command is incorrect.
System Activate Virtual Remote Control Mode A/B Operate description:
MODE A： ： ： ：
[COMMAND]
------------------------- -------------------------------------------
1 2 3 4
-
+
L
R
[DESCRIPTION]
Currently select input and disable auto scan.
Select previous available input and activates auto scan.
Select next available input and activates auto scan.
Auto scan function activated/disabled.
Auto jump function activated/disabled.
System activate.
System standby.
Select operation mode A/B.
IR remote button lock/unlock.
Panel button lock/unlock.
LED brightness adjustment.
Save setting.
Load setting.
Keypad mode operation.
Display input signal status.
Display setting.
Display firmware version.
Show all commands.
[PARAMETER]
1 | 2 | 3 | 4
A | B
ON | OFF
[DESCRIPTION]
Currently select input and disable auto scan.
Select previous available input and activates auto scan.
Select next available input and activates auto scan.
Select previous input and disable auto scan.
Select next input and disable auto scan.
5
Advertisement
