Beach Buddy Tm - Go-Float 2012 ION Owner's Manual

Upright, Temporary: Be sure that the battery hold down strap is
secured. Remove all items from the cooler-storage compartment and
the passenger area. Open the drain plug, located on starboard (right)
side of the hull. Tip the boat on its starboard (right) side to make sure
water is drained from inside the hull. Replace the plug. Then rest the
boat on a flat surface on the Beach Buddy and raise the bow until the
boat is completely upright and resting on its transom. Be sure that your
Go-Float is out of the wind so as not to blow over.
Upright, Long Term: Follow the above procedure, but to extend the life
of your battery, remove it first. Store the battery on a wooden surface,
such as a piece of lumber, indoors. Use a trickle charger about every 4
-6 weeks to keep the battery powered up.
IMPORTANT! Use a heavy line attached to the bow eye to secure your
Go-Float to a solid fixture, such as a rafter. This will prevent your Go-
Float from accidently falling over if bumped.
Drain plug, shown closed.
Located on starboard (right) side
of hull.
Beaching
IMPORTANT! When your Go-Float
is on shore in a horizontal position,
it is recommended that you do not
step into the boat. Serious damage
may occur to the hull, deck, and
TM
Beach Buddy .
Battery
The battery is sealed, so do not
worry about it leaking during upright
storage.
Storage