Playback Operations; Alarm Operation - Telefunken TF-AS1203U Instruction Manual

USB/SD operation
Connecting USB/SD
• Insert a USB device into the USB port or
insert a memory card into the memory card
slot. The unit will switch to USB or SD mode
automatically. The unit will start reading the
device, LOAD will be displayed.
• When the device and tracks on it are
detected, the display shows the currently
playing track number, track playback time and
operation mode in turn.

Playback operations

• During playback press
or /PRESET button on the panel to pause
playback. Press this button again to resume
playback.
• During playback press
go to previous or next track.
• During playback press SHUFFLE button
to enable random playback of tracks. Press
REPEAT button for repeated playback of one or
all tracks.
General USB/SD notes
• This unit is equipped with a USB socket
that can accept and play MP3 files stored on
standard USB flash (compatible with USB
version 2.0) up to 8 Gb.
• This unit is also equipped with an SDcard
socket that can accept and play MP3 files
stored on standard SD cards up to 8 Gb.
Always switch off the unit or change
mode to another one before removing a USB
flash drive or SD card, to prevent damage to
your USB device or memory card.
Note: Although this product is fully
compatible with USB 2.0 and SD card standard
formats, a small percentage of USB flash
drives and SD cards might not be readable,
due to those device manufacturers' non-
compliance with the full (official) USB and SD
card standards.
• FAT32 file system is supported by USB
and SD of this unit.
usage of a USB device with power current
consumption exceeding 500 mA is not
recommended without supplementary power
supply. Failure to use supplementary power for
connected USB drives with power consumption
exceeding this value as well as defective
USB drives may cause mechanical or thermal
changes of elements of this unit as well as
failure of internal elements of the USB port.
Such damages are not warrantee cases.
containing BIN files in root directory may cause
malfunction of unit or damage to the software.
button on the RC
/ buttons to
on the RC or VOL-/ALARM1 button on the
panel; the last set alarm time will be displayed.
Press and hold this button to enter the 1st
alarm setting mode. Hour digits will blink. Press
repeatedly
BED TIME (VOL-/ALARM1) button again;
minute hours will blink. Press repeatedly
buttons to set minutes. Press BED TIME (VOL-/
ALARM1) button to confirm the alarm time.
ALARM1) button to select the alarm sound in
turn: buzzer => radio => USB => SD. The icon
of the selected alarm mode will be marked with
a blue light indicator.
listened frequency will be played when the
alarm time comes. If USB/SD is set as alarm
sound, the last listened track will be played
when the alarm time comes. If USB or SD
Instruction manual
According to the USB 1.1/2.0 Standard,
Warning: use of external USB drives

Alarm operation

Alarm 1
• In standby mode press BED TIME button
/ buttons to set hours. Press
• Press repeatedly BED TIME (VOL-/
• If radio is set as alarm sound, the last
/
5
5