Toyota TNS 300 Installation Instructions Manual page 18

LAND CRUISER
12P (White)
Wire harness TX+ sensor wire (Yellow)
2
Wire harness TX- sensor wire (Yellow / Black)
2
Figure 32
Wire harness (speed sensor wire and reverse sensor wire)
2
8 Foam tapes x 2
10P (White)
Figure 33
Heater control panel
Bolt
Clips x 4
Figure 34
Tab
10 9
Wire harness side 12P
Vehicle wire harness
Wire ties x 2
9
Bolts x 5
LAND CRUISER (LHD) - 18
12. Connect the TX- sensor wire (Yellow /
Black) of the wire harness
12P connector (White) terminal 9 har-
ness.
13. Connect the TX+ sensor wire (Yellow)
of the wire harness
nector (White) terminal 10 harness.
14. Reconnect the 12P connector (white) to
the heater control panel.
15. Secure the wire harness
cle wire harness using the wire tie
16. Secure the extra length of the wire har-
2
ness (speed sensor wire and
reverse sensor wire) as shown in the
illustration using the foam tapes
17. Connect the wire harness
nector (White) to the vehicle side 10P
connector (White).
18. Refit the heater control panel.
TNS 300
2
to the
2
to the 12P con-
2 to the vehi-
.
9
8
.
2
10P con-