Advertisement
EXTERNAL
FILTER RACK CONVERSION
KIT CAT# 16L23 AND
16L24)
From Right S de to Left S de Conf gurat on
A=
C
FILLER PIECE_
... --_
FRAME
HOLDING ANGLE
_
-_.
SECURING SCREW
I
16 INCH (40.6 CM)_
I
BOTTOM HOLDING ANGLE _
Right side configuration
I_
Intermediate
step
f
E_>
Left side configuration
To convert
to left
side
configuration:
1 - Remove screws securing
filler piece to frame. See detail A.
2 - Flip filler piece 180 degrees and secure to bottom
of frame. See detail B.
3 - Remove bottom
holding
angle, flip 180 degrees and secure to top of frame. See detail B.
4 - Flip frame 180 degrees to give orientation
as in detail C.
FIGURE 2
SECURING
SCREW
_--_-_____
=
FRAME
FILLER PIECE --
HOLDING
ANGLE
EXTERNAL FILTER RACK CONVERSION
(KIT CAT# 16L23 AND 16L24)
From 16 inch (40.6 cm) Filter Size to 20 inch (50.8 cm)
Left Side Orientation Shown
NOTE - THIS CONVERSION IS ALSO RECOMMENDED IF
__
FILTERIS NOT INSTALLED IN RACK, BUT IS LOCATED
ELSEWHEREIN RETURN AIR DUCT.
TO convert
from
16 inch (40.6 cm)
to 20 inch (50.8 cm) filter
size:
1 - Remove screws securing filler piece to frame.
2 - Remove holding angle from filler piece. Discard filler piece.
_.
3- Re-secure ho d ng ang e to top of frame.
16 INCH
(40.6 CM)
FILTER
20 INCH (50.8 CM)
FILTER
FIGURE 3
Page 5
Advertisement
