MTD 510 Series Operator's Manual page 16

11. Refill the reservoir within range marked on the dipstick.
See Fig. 6-2.
Dipstick
MAX
12. Extend and retract the wedge 12 complete cycles to
remove trapped air in the system (the system is "self-
bleeding").
WARNING!
drawn into the cylinder and hoses. Make certain to
refill the reservoir to prevent damage to the
hydraulic pump. Failure to refill the tank will void the
log splitter's warranty.
NOTE: Some fluid may overflow from the vent plug as
the system builds heat and the fluid expands and seeks a
balanced level. Do not operate the log splitter without the
proper amount of transmission fluid in the reservoir tank.
Maintain the fluid level within the range specified on the dipstick
at all times. When checking the fluid, always make sure to tighten
the dipstick until the top of the threads are flush with the top of
the pipe.
NOTE: Always dispose of any used hydraulic fluid and
engine oil at approved recycling centers only.
Contaminants in the fluid may damage the hydraulic
components. Flushing the reservoir tank and hoses with
kerosene whenever service is performed on the tank, hydraulic
pump or valve is recommended. Contact an authorized service
dealer.
Beam and Splitting Wedge
• Lubricate top, sides and bottom of the beam and where it
comes into contact with the splitting wedge with engine
oil before each use.
16 s 6— M
ectiOn aintenance
MIN
Hydraulic Fluid
Only
Figure 6-2
Much of the original fluid has been
& a
djustMents
Off-Season Storage
If the log splitter will not be used for more than 30 days, prepare
it for storage as follows:
WARNING!
Never store the machine with fuel in
the fuel tank inside of building where fumes may
reach an open flame or spark, or where ignition
sources are present such as hot water and space
heaters, furnaces, clothes dryers, stoves, electric
motors, etc.
1. Refer to the Engine Operator's manual packed with your
log splitter for information on the off-season storage of the
engine.
2. Clean the log splitter thoroughly.
NOTE: The use of pressure washers or a garden hose to
clean the splitter is not recommended. They may cause
damage to the bearings or the engine. The use of water will
result in a shortened life and reduce serviceability.
3. Wipe the machine with an oiled rag to prevent rust,
especially on the wedge and the beam.
4. Store the log splitter in a clean, dry area. Do not store it
next to corrosive materials, such as fertilizer.
NOTE: If storing in an unventilated or metal storage shed,
be certain to rustproof the equipment by coating it with a
light oil or silicone.