Security Tronix ST-PTZMINI-IR10X Installation Manual page 7

Instructions
Power On Action
IR SPEED DOME
PROTOCOL
COMM
DOME ID
MODULE
VERSION
PAN
TILT
POWER ON
IR SPEED DOME
PROTOCOL
COMM
DOME ID
MODULE
VERSION
PAN
TILT
POWER ON
IR SPEED DOME
PROTOCOL
COMM
DOME ID
MODULE
VERSION
PAN
TILT
POWER ON
7
When initializing the system, the display shown at left will appear roughly 5
seconds after powering the camera.
When restoring the original factory settings it will take roughly 1 minute for
the camera to restore all settings and reboot.
PELCO-D/P
2400.N.8.1
This display indicates that the camera is initializing the pan and tilt
001
motors.
V1.2
INIT
INIT
The initialization of pan and tilt motors is now complete. The camera is now
initializing and detecting the module of camera.
PELCO-D/P
.
2400.N.8.1
001
V1.2
INIT
INIT
The display now indicates that "ST-370" is the specific model of camera
module which is installed. This is displayed after the camera finishes detection.
Self testing is now complete.
PELCO-D/P
2400.N.8.1
001
ST-370
V1.2
INIT
INIT