Routine Maintenance - Whitfield P/N 775 024M Rev. C Installation And Operation Manual

ROUTINE MAINTENANCE

* Inspect your stove at minimum frequency stated until you establish a minimum frequency required for your instal-
lation (frequency will vary depending upon fuel BTU value / ash content, usage, and misc. installation variables).
ROUTINE CLEANING
Note: Stove will need to be shut off and cooled enough to
handle before routine cleaning is performed. Always dis-
connect power before doing any routine cleaning.
The following areas need to be inspected during routine
cleaning:
•
UltraGrate (burn grate)
•
Ash Slide Plates
•
Ash Pan
•
Heat Exchange Tubes
•
Exhaust Passages and Vent Pipe
Maintenance Reference Diagram
Left Exhaust
Passage
Clean-out
Plate
Ash
UltraGrate
Slide
Plates
Grate Scraper /
Ash Slide
Ash Pan Tool
Plates
Exhaust
Right Exhaust
Passage Clean-
out Plate
ULTRAGRATE (BURN GRATE)
The UltraGrate should be inspected periodically to as-
sure that the air holes have not become clogged with ash
or clinkers. The UltraGrate can easily be cleaned with
the grate scraper / ash pan tool, or it can be removed for
cleaning. It is very important to monitor the ash build up
under the UltraGrate, as excessive amounts of ash will
block combustion air from entering the grate, causing
pellets to pile-up in the grate.
UltraGrate
Housing
Exhaust
Grate Scraper
* (Recommended Frequency of 1 day – 2 weeks)
Page 18
Cleaning UltraGrate
UltraGrate