Bosch is not responsible for improperly installed, tested, or maintained devices. The D7050DH complies with Part 15 of the Federal Communications Commission (FCC) Rules and with the RSS-210 of Industry and Science Canada. D7050DH operation is subject to the following two conditions: 1.
3. Mount and wire the duct housing according to the 2 - Multiplex bus connections D343 Installation Instructions (P/N: 48199). 4. Mount the D7050DH to the base by turning it clockwise until it clicks into place (Figure 4). 4.0 Setting the Address...
1. Apply power to the system and check for alarms. whether or not the detector is within its factory marked 2. If a D7050DH is in alarm, shut down the system. calibration range. 3. Remove the D7050DH and recheck for proper 7.2.1...
Insert the screwdriver into the cover slots every 2 sec) and the detector goes into alarm. and pry off the cover (Figure 5). 3. If the D7050DH is not operating, it does not signal Figure 5: Removing the 7050DH Cover an alarm.
7. Replace the D7050DH’s cover, lining up the holes Instructions (P/N: 48199), the DS9400M Current Reference Guide (P/N: 44578), and the for the LED. DS6431 Installation Instructions 8. Return the D7050DH to its base and replace the (P/N: 41381) D343’s cover. Minimum 8 VDC peak Operating...