Manual Transmission 1 To 4 Skip Shift - Dodge 2013 VIPER SRT User Manual

O PE RAT ING YOUR VE HI CL E
SET
• With the Speed Control on, push and release the SET – button to set a desired speed.
Accel/Decel
• Once a speed is set, pushing the RES + button once or the SET – button once will
increase or decrease the set speed approximately 1 mph (2 km/h).
• Push and hold the RES + button to accelerate in 5 mph (8 km/h) increments or push
and hold the SET – button to decelerate in 5 mph (8 km/h) increments; release the
button to save the new set speed.
Resume
• To resume a previously selected set speed in memory, push the RES + button and
release.
Cancel
• Push the CANCEL button, or apply the brakes to cancel the set speed and maintain the
set speed memory.
• Push the ON/OFF button to turn the system off and erase the set speed memory.
• Leaving the Electronic Speed Control system on when not in use is dangerous. You
could accidentally set the system or cause it to go faster than you want. You could
lose control and have a collision. Always leave the Electronic Speed Control system
off when you are not using it.
• Electronic Speed Control can be dangerous where the system cannot maintain a
constant speed. Your vehicle could go too fast for the conditions, and you could lose
control. A collision could be the result. Do not use Electronic Speed Control in
heavy traffic or on roads that are winding, icy, snow-covered or slippery.

MANUAL TRANSMISSION 1 TO 4 SKIP SHIFT

1
3 3 5 5 R R
Skip
Shift
2 2 6
• For optimal fuel economy, under low acceleration conditions, your vehicle will only
allow you to shift from first gear to fourth gear. Additionally, the skip shift message will
appear in the tachometer.
• Refer to your Owner's Manual on the DVD for further information.
WARNING!
• Skip Shift is enabled when vehicle speed is greater than 16 MPH
(26 km/h) but less than 18 MPH (29 km/h) and the accelerator is
at 20% or less.
21