Chevrolet 2015 Corvette Owner's Manual page 231

10-18 Vehicle Care
1. Open the bonnet. See Bonnet
on page 10-6.
2. Remove the four bolts (1) and
the bonnet extractor duct (2).
3. Reverse Step 2 to replace the
bonnet extractor duct.
To inspect or replace the engine air
cleaner/filter:
1. Surge Tank Coolant Hose
2. Screws (2)
3. Hose Retainers (2)
4. Air Duct Clamp
5. Electrical Connector
Caution
If the engine coolant surge tank
hose is not carefully lifted out of
the hose retainers on the air
cleaner/filter cover assembly, it
may be damaged and cause
engine coolant to leak. Damage
would not be covered by the
vehicle warranty.
1. Carefully lift the surge tank
coolant hose (1) from both hose
retainers (3) and position the
hose to be able to remove the
screws securing the air cleaner/
filter end cap.
2. Loosen the air duct clamp (4) at
the air cleaner/filter housing end
cap and move the duct out of
the way.
3. Remove the electrical
connector (5) from the sensor.
4. Remove the two screws (2).
5. Turn the air cleaner/filter end
cap downward and disengage
the lower end cap mounting tabs
from the lower retention hinge
features. Be sure to insert the
lower end cap mounting tabs
fully into the housing retention
hinge features before turning the
end cap upward and replacing
the screws.
6. Inspect or replace the air
cleaner/filter.
7. Reverse Steps 1 6 to replace
the air cleaner/filter end cap.