Table of Contents
Advertisement
LAYOUT OF EACH CONTROL
Note :
If you are unable to adjust the corner convergence
properly, this can be corrected with the use of
permalloys.
a
a-d: screen-corner
convergence defect
c
Permalloy Assy
X-4387-214-1
Convergence adjustment with permalloy.
Purity magnet
BMC (Hexaploe) magnet
V STAT convergence magnet
Y-splitting axis correction magnet
Fig 3-6
b
d
3-3. SCREEN (G2)
SCREEN G2 ADJUSTMENT
1.
Input a dot signal from the pattern generator.
2.
Set the Picture, Brightness and Colour to minimum.
3.
Apply 175V DC from an external power supply to the
R, G and B cathodes of the CRT.
4.
Whilst watching the picture, adjust [SCREEN G2] located on
the FBT [flyback transformer] to the point just before the
flyback return lines disappear.
3-4. FOCUS
1.
Receive a television broadcast signal.
2.
Normalise the picture setting.
3
Adjust the focus control located on the FBT [flyback
transformer] to obtain the best focus at the centre of the screen.
Bring only the centre area of the screen into focus, the
magenta-ring appears on the screen. In this case, adjust the
focus to optimize the screen uniformly.
22
FOCUS
SCREEN (G2)
Advertisement
Table of Contents
