Advertisement
For EDVST Model Only
Step 1 - Remove the
two #8 screws from
the bracket screw
cover on both sides.
Step 2 - Remove the
two #10 screws from
the firebox bottom
on both sides (save
screws).
Step 3 - Install the Firebox Bottom Cover Panel (#5 in Figure 1) using the
existing #10 screws. The bottom two holes on the cover panel align to cor-
responding two holes on fi rebox bottom.
- Install Firebox Cover
Figure 5b
4. For EDV, EDVST & EBVST models, reinstall modesty panel, ensuring all
wires are securely connected.
5. Install Doorframe (see Figure 6) - Remove the arched doorframe
from packaging. Position the top of the doorframe above the top of the
glass doorframe (centered and approximately 1" above the top of the
glass doorframe). Slide down so that the hooks catch on the back of
the doorframe slide between the sides of the glass door and the corner
posts engaging into existing slots on fi replace.
Left
Corner
Post
Figure 6
- INSTALL DOORFRAME
6. Place the doorframe bracket in the locked position as shown in Figure 7.
Bracket
Screw
Cover
#8
Screw
#10 Screw
Doorframe
Right
Corner
Post
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Adjust Doorframe Bracket
Locate the doorframe
bracket on the lower front
of the doorframe and lock
it behind the cabinet
bottom fl ange as
shown here.
Figure 7
7. Remove the screen doors from packaging. Install them by aligning
hinge pins on the doors with the hinge holes on the doorframe and
slide down (see instructions in Figure 8). Ensure the hinge pins are
fully seated onto the shoulders of the hinge holes.
Firebox
Figure 8
Doorframe
Bracket
Align hinge pins on the
doors with the hinge holes
on the doorframe and slide
down as shown.
Hinge Pin
Firebox
3
Advertisement
