Oracle 1.6TB NVMe SSD User Manual page 37

5. Verify removal of the NVMe storage drive.
Follow the server's service manual instructions for NVMe storage drive identification.
6. Install (or replace) the NVMe storage drive.
The drive is physically addressed according to the slot in which it is installed. It is important to
install a replacement drive in the same slot as the drive that was removed.
Refer to "Supported Servers and Operating Systems" in "Oracle Flash Accelerator F160 PCIe
Card and 1.6TB NVMe SSD Product Notes
a. Slide the drive into the vacant slot by pressing the middle of the drive
faceplate with your thumb or finger.
Slide the drive into the slot until the drive is fully seated.
b. Close the drive latch to lock the drive in place.
Using your thumb or finger, press on the middle of the drive faceplate until the release
lever engages with the chassis. Close the release lever until it clicks into place and is flush
with the front of the server.
Replace An Existing NVMe Storage Drive (CRU)
".
Servicing the NVMe Storage Drive 37