Table of Contents
Advertisement
This drive serial number (WWN) and server slot information can be used at a later time for
identifying drives from the console.
Refer to the server's service manual.
6.
If necessary, remove the drive filler panel.
Remove the blank storage drive filler panel on the server chassis that aligns with the empty
NVMe drive slot.
For instructions on how to remove drive filler panels, refer to the server's service manual.
7.
Slide the Oracle 1.6TB NVMe SSD into the supported NVMe slot until the drive is
fully seated.
The following figure shows how to insert the SSD in a server NVMe slot:
Close the drive latch to lock the drive in place.
8.
9.
Configure the server for the new SSD.
a.
If applicable, perform any required commands for your system to install the
device driver for the new SSD.
If applicable, perform any required commands for your system to recognize
b.
the new SSD.
c.
Verify successful installation of the SSD through your system's OS.
Upon completed installation, the Oracle 1.6TB NVMe SSD is visible to your server
operating system.
d.
Configure the system to maximize flash technology.
Refer to the server's administration guide.
Install a New NVMe Storage Drive (CRU)
Installing the NVMe Storage Drive
31
Advertisement
Table of Contents
