Table of Contents
Advertisement
a . Type 1 Headlamps: The projected beam
should be centered vertically and horizon-
tally on the vertical surface as marked in
step 6 and 7 .
b . Type 2 Headlamps: The top edge of the
projected beam is to even with a horizontal
line parallel to a line formed by the two
head lamp filament centers and to the right
of the vertical center line of each head
lamp .
9 . If the headlamps do not meet the align-
ment criteria adjust the "Vertical "and/or
"Horizontal" positioning as shown on the
attached figure, rotate the knobs and/or
screws on the head lamp . When turning the
knobs and/or screws watch the direction in
which the projected beam moves to help
understand which direction on the beam
moves in relation to turning each .
10 . Remember, this procedure is only a
guideline and is not a substitute for having
headlamps professionally aligned .
on the road
05-21
Advertisement
Table of Contents
