Download Print this page
ACU-RITE Atomic Clock Instruction Manual
ACU-RITE Atomic Clock Instruction Manual

ACU-RITE Atomic Clock Instruction Manual

Advertisement

Quick Links

Instruction Manual
Clock/Thermometer
DO NOT HANG IN DIRECT SUNLIGHT!
For the most accurate temperature readings choose a location
that will not be exposed to direct sunlight or other heat
sources.
To Set Time:
Turn the set knob on back of the clock movement in either
direction.
To Start Clock:
Clock requires one "AA" battery (not included).
Insert one "AA" battery (not included) as indicated in the
battery compartment.
Thermometer Calibration:
The pointer may move during shipping, causing the
thermometer to read temperature inaccurately. If the
thermometer is reading incorrectly, compare the temperature
reading to a known accurate thermometer. Let both
thermometers adjust to room temperature for at least three
hours. If the new thermometer continues to read inaccurately,
adjust the pointer by turning knob on the back of the unit in
the approriate direction.
Questions?
Contact Customer Support at
(877) 221-1252 or visit www.AcuRite.com.

Advertisement

loading
Need help?

Need help?

Do you have a question about the Atomic Clock and is the answer not in the manual?

Questions and answers

Jeannie
March 16, 2025

every since time change my alarm doesn't go off . Can not figure out

1 comments:
Mr. Anderson
May 14, 2025

The alarm on your ACU-RITE Atomic Clock may not be going off after the time change because the clock did not receive the atomic signal. If the clock does not receive the signal within 12 minutes, you should restart the setup process by pressing the "RESET" button. Also, atomic clocks may not work properly in windowless rooms or areas with heavy cement walls, which can block the signal. Allow up to 24 hours for the clock to adjust to the correct time.

This answer is automatically generated

Lynn
April 9, 2025

need to set date and day

Summary of Contents for ACU-RITE Atomic Clock

  • Page 1 Instruction Manual Clock/Thermometer DO NOT HANG IN DIRECT SUNLIGHT! For the most accurate temperature readings choose a location that will not be exposed to direct sunlight or other heat sources. To Set Time: Turn the set knob on back of the clock movement in either direction.
  • Page 2: Atomic Clock

    • Consult the dealer or an experienced radio/TV technician for help. NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user authority to operate the equipment. Atomic Clock Instruction Manual ATOMIC INST 071012...
  • Page 3 Overview SETUP Introduction Chaney and AcuRite atomic clocks use a radio-controlled signal to 4. Insert one fresh 1.5 volt “AA” battery in the battery synchronize to the correct time broadcast by the National Institute compartment (A) to power on the clock . of Standards and Technology (NIST) Radio Station WWVB, 5.
  • Page 4: Troubleshooting

    CARE TROUBLESHOOTING • Replace battery annually or when the clock cannot receive the Problem Possible Solution(s) atomic signal. • Keep clock clean, dry and dust-free by cleaning it regularly with a soft cloth. • Place clock near a window with the •...
  • Page 5: Important Notice

    TROUBLESHOOTING IMPORTANT NOTICE Problem Possible Solution(s) YOUR PRODUCT MUST BE REGISTERED TO RECEIVE WARRANTY SERVICE If the clock is inaccurate, force the clock to search for the atomic signal using the PRODUCT REGISTRATION following steps: Register this product • Press and hold the “REC” button (D) to receive 1-year for 3 seconds.