Table of Contents
Advertisement
THE REMOTE CONTROL
Using Direct Entry
1. Turn on the component you want the remote to operate.
2. Look up the brand and code number(s) for the component on the
code list on page 7.
3. Press and hold the component button that corresponds to the
component you want the remote to operate (VCR1, VCR2, SAT•CABLE,
or AUX)
4. Enter the code from the code list.
5. Release the component button.
6. Press ON•OFF to see if the component responds to the remote
commands. If it doesn't, try pressing the component button and then
ON•OFF again.
7. If you get no response, repeat these steps using the next code listed
for your brand until the component responds to the remote
commands.
How to Use the Remote After
You've Programmed It
Once the remote has been programmed successfully, you are ready to use it
to control your components. To operate the component:
1. Press the component button (VCR1, VCR2, SAT•CABLE, or AUX) to set
the remote to operate the component.
2. Press ON•OFF to turn the component ON or OFF.
3. Use the remote buttons that apply to that component.
Note: If you keep pressing buttons and nothing happens, the
remote is probably in the wrong mode. You must press the
component button that matches the component you want to
operate (i.e., if you want to operate the VCR, press VCR1 on
the remote control to put the remote in VCR mode.)
6
Tip
The buttons might operate differently
for other components, especially
when you're using another
component's menu system.
Advertisement
Table of Contents
