Table of Contents
Advertisement
CONNECTION
INTEGRATED Controller WTX-1200A Keyboard
can be used to connect&control DVR, MULTIPLEXER and other external devices.
RS-485/422 Connection
External device's RS-485/422 port is connected to this Keyboard's RS-485/422 terminal block.
When RS-485/422 connection, be careful +, - polarity not be changed.
And check device's RS-485/422 support is available or not.
DVR Connection
Connect USB cable of this equipment to DVR.
Press the top of the controller's
button.
If you briefly press : Camera control mode is switched on the keyboard.
If you press and hold : Mouse function is activated through USB Port.
If you briefly press, displays are as follows:.
Transfer speed is 9600bps, Control ID is 001.
DVR WKRY 9.6
Display ID is DVR ID.
ID : 001
If you want to control other ID DVR, push number key and ENT then ID will be changed.
(EX. No.3 button + press
for 3 seconds)
ENT
* Constant value for each button, for each communication (COMMAND) has been set.
WTX-1200A and DVR mouse function use.
Press and hold the mouse button to start the feature.
DVR WKRY 9.6
Mouse function will start as phrase(MOUSE) flashing on the screen.
MOUSE
ID : 001
1.DVR must be PC compatible.(Device driver required)
2.DVR Power ON
3.WTX-1200A Power ON
4.Mouse speed setting in the main setup (WTX-1200A 2 +
5.WTX-1200A and DVR connected.
6. If you press and hold
button, you can see phrase(MOUSE) flashing on the screen.
7. Check the mouse pointer on the screen.
8. Mouse function used as joystick control.
USE 'L', 'R' button of mouse
)
Use mouse-pointer moving
SYSTEM CONFIGURATION
Single system configuration (Camera 1, kyeboard 1, DVR 1)
DVR PORT
Tx+
Tx-
Rx+
Rx-
Tx1+ Tx1- Tx2+ Tx2- Tx3+ Tx3- Trx+ Trx-
DVR PORT
Tx+
Tx-
Rx+
Rx-
Tx1+ Tx1- Tx2+ Tx2- Tx3+ Tx3- Trx+ Trx-
PTZ
Rx +
Rx -
PTZ
Rx +
Rx -
Advertisement
Table of Contents
