Sony NWZ-S715F Quick Start Manual page 36

FMRadio
Symptom
You cannot hear an
FM broadcast well.
Reception is weak and
sound quality is poor.
The FM broadcast is
affected by
interference.
Other
Symptom
There is no beep
sound when the
player is operated.
The player gets warm.
The screen turns on
whenever songs
change.
The date and time
have been reset.
Noise is generated
when the headphones
are con neeted or
disconnected from
Ihe player.
CauselRemedy
• The receiving frequency is not fully tuned in.
~
Select the frequency manually to improve reception using the I:J./'V button
(@"
page 72).
• The radio signal is weak.
-+
Listen to the FM broadcast near a window since the signal may be weak inside
buildings or in vehicles.
• The headphone cord is not fully extended.
-+
The headphone cord functions as an antenna. Extend the headphone cord as
far as possible.
• A device emitting radio signals, such as a mobile phone is being used near the
player.
-+
When using devices such as mobile phones, keep them away from the player.
CauselRemedy
• "Beep Settings" is set to "Off:'
-+
Set "Beep Settings"
10
"On"
((jY
page 81).
• The beep does not sound when the player is connected to the optional cradle, or
another device.
• The player may be warm when the battery is being charged and just after
charging. The player also may get warm when a large amount of data
is
transferred. This behavior is normal and not cause for concern. Set the player
aside for a while to allow it to cool down.
• "New Song Pop Up" is set to "On."
-+
Set "New Song Pop Up" to "Off" «(jY page 32).
• If you left the player for a while with the battery used up, the date and time may
be reset. This is not a malfunction. Charge the battery until
g
appears on the
screen and set the date and time again
(@~
page 85).
• Connect or disconnect the headphones from the headphone jack of the player
after removing the headphones from your ears. [f the headphones are connected
or disconnected from the player during playback or while the Noise Canceling
function is active, noise may be generated. This is not a malfunction.
To initialize (format) the player
Be sure to format the built-in flash memory using the Menu mode on
this player following the procedure below. (Check all contents before
formatting as all data stored will be erased.)
1 Press and hold the BACK/HOME button in the pause mode
until the Home menu appears.
2 Select
~
(Settings)-"Common Settings" - "Format" - "Yes" -
"Yes:' in this order.
Press the /:;./\1/ <J/t> button to select the item, and then press the t>DD
button to confirm.
After selecting "Yes" and confirming, "Formatting.. :' appears and
formatting starts. When formatting is complete, "Memory
formatted." appears.