Mitsubishi AJ71E71N-T User Manual page 13

No. Designation
1) Display LED
2) Operation mode setting switch Refer to (2)
Exchange condition setting
3)
switch
4) 10BASE-T connector (RJ45)
External power supply
5)
indicator lamp
External power supply
6)
terminal
7) AUI cable connector
8) 10BASE2 connector
(1) Display LED display contents
Display LED
RUN Normal operation display
RDY Exchange ready end display
Exchange processing executing
BSY
display
SW.ERR. (For system)
COM.ERR. Exchange error detection display
Exchange processing executing
CPU R/W
with PLC CPU display
Display of communication line
BUF1 to
connection status of connection
BUF8
No.n corresponding to BUFn.
TEST Self diagnostic executing display
TEST ERR. Self diagnosis results display
Refer to (1)
Refer to (3)
Connector for connecting the E71 to the 10BASE-T.
Lamp for verifying if power is being supplied to the
transceiver.
ON:
OFF: Power not supplied
Power source terminals for power source supply to
the transceiver.
AJ71E71N-B5
A1SJ71E71N-B5: 13.28 V to 15.75 V
Connector for connecting the E71 to the 10BASE5.
(For connection of 10BASE5-use AUI cable
(transceiver cable))
Connector for connecting the E71 to the 10BASE2.
Display contents
Contents
Power supplying
: 14.08 V to 15.75 V
When lamp is lit
Normal
Starts flashing when On-line
Operations begin
Turns on when exchange processing
with remote node is being executed.
—
Exchange error
Exchanging
Open completed
Self diagnosis
executing
Error
6
Lamp is not lit
Error
—
Normal
Not exchanging
Closed status
Self diagnosis
completed
Normal