Advertisement
devices. A building can withstand up to 100,000 volts, but electrical equipment may
be damaged by just a few volts.
Direct earth grounding of the antenna and the Lightning Protector is necessary to
protect the installation from lightning and the build-up of static electricity.
The ground terminal is located on the lightning protector that attached with this
unit. Connect one end of the grounding cable to the Ground terminal and the other end
to a good ground connection.
This power amplifier can be mast mounted using the stainless steel U-bolts as shown
in Figure 5 and Figure 6. Refer to the sketch for proper positioning. Carefully tighten
the bolts using the included nuts. Take care not to over-tighten the bolts or cause
damage to the RF connectors on the amplifier. Because the amplifier is a sealed unit,
these connectors can not easily be repaired.
This unit can also be mounted to a flat surface using any of the mounting holes on the
unit's mounting flanges.
Mounting Instruction
Advertisement
