Table of Contents
Advertisement
Quick Links
This equipment must be installed and serviced by a qualified technician in accordance with all applicable codes
and ordinances. Improper installation can create hazards which could result in property damage, serious injury
or death. Improper installation will void the warranty.
The NOTICE label indicates special instructions that are important but not related to hazards.
1
-
QUICK START QUIDE
OWNER'S MANUAL
INSTALLATION, OPERATION & PARTS
POOL PUMPS
SINGLE SPEED & 2-SPEED
！
Notice to Installer
This manual contains important information about the installation, operation and
safe use of this product. Once installation is complete, this manual must be
given to the owner/ operator of this equipment.
WARNING
-
Advertisement
Table of Contents
Related Manuals for Aqua PRO SINGLE SPEED
Summary of Contents for Aqua PRO SINGLE SPEED
- Page 1 QUICK START QUIDE OWNER’S MANUAL INSTALLATION, OPERATION & PARTS POOL PUMPS SINGLE SPEED & 2-SPEED ！ WARNING This equipment must be installed and serviced by a qualified technician in accordance with all applicable codes and ordinances. Improper installation can create hazards which could result in property damage, serious injury or death.
- Page 2 Description The self-priming pool pump is designed for high efficiency and easy installation and maintenance. It is constructed for years of trouble-free service. This swimming pool pump is designed for use with permanently installed swimming pools only. Unpacking After unpacking the unit, carefully inspect for any damage that may have occurred during transit. Check for loose, missing or damaged parts INSTALLATION Only qualified, licensed personnel should install pump and wiring.
- Page 3 THREADED CONNECTIONS Use only Teflon® tape or equivalent on threaded plumbing connections. Other pipe compounds may damage threads. Do not use silicone or petroleum based compounds. Do not over tighten. Hand tightening plus 1/2 turn is sufficient. PUMP PLUMBING Suction pipe should be as large as or larger than discharge pipe. Avoid using a suction pipe smaller than the pump connection.
- Page 4 Suction inlets must be designed so that water is drawn simultaneously. A vacuum relief device can be installed in line leading to the pump suction. All suction outlet covers must conform to ASME/ANSI A112.19.18M; or must be a minimum 18 x 23 grate or larger; or must have an approved channel drain system.
- Page 5 A Ground Fault Circuit Interrupter (GFCI) is required in the circuit. For size of GFCI required and test procedures for GFCI, please see manufacturer’s instructions. OPERATION Avoid running the pump dry. Fill the pump with water before starting motor. Before removing the trap cover: 1.
- Page 6 E. Prime the pump (see priming instructions). Draining the Pump A. Pump down water level below all inlets to the pool. To avoid dangerous or fatal electrical shock hazard, turn OFF power to the motor before draining pump. B. Remove the basket cover C.
- Page 7 MECHANICAL TROUBLES AND NOISE 1. If suction and discharge piping are not adequately supported, pump assembly will be strained. See “Installation”. 2. Do not mount the pump on a wooden platform! Securely mount on a concrete platform for quietest performance before working on pump or motor.
-
Page 8: Limited Warranty
Limited Warranty For one (1) year from the date of purchase, manufacturer will repair or replace, at its option, for the original owner any parts of its pumps (“Product”) which are found upon examination to be defective in materials or workmanship. Please call 1-877-278-2797 for instructions.
Need help?
Do you have a question about the SINGLE SPEED and is the answer not in the manual?
Questions and answers