Correct use To avoid the risk of personal injury or damage to the washing machine, do not install it in place where it is damp and where Read and understand thoroughly these safety instructions it suffers from rainfall. before use. The items indicated here are very important Do not install the washing machine in place where it suffers safety precautions, which must be followed.
Page 4
Remove all the packing ( including the foam base) or the vibration and noise may occur. Dispose all the wrappage safely and keep them out of the reach of children. Danger of suffocation! It is normal that water drops appear on the packing plastic bag and the door glass, which are resulted from the water left in the tub for checking out.
2. Connected securely to a standpipe. Firstly form a hook in the end of the drain hose using the “U” piece” A concrete floor is the most suitable installation surface supplied. for a washing machine, being far less prone to vibration Place the drain hose into your standpipe, which should have an internal diameter of approximately during the spin cycle than wooden floorboards or a carpeted 38mm thus ensuring there is an air break between the drain hose and standpipe.
Page 6
For your safety, please not turn the knob to the position “ ” and get clothes while the machine is running. Because the temperature of water may be high and it may scald you. The door lock will open automatically at the end of a wash cycle while the tem- Synthetic Standard Cotton perature of the drum is cool down.
Page 7
these: 1. Open the drawer and add adequate detergent into main wash compartment marked “ ” or “ ”. 2. Add the fabric softener into compartment marked “ ” or “ ” . Turn the knob to position “standard cotton”. Do not exceed the maximum level mark.
Washing programme chart Disconnect the machine from the mains electricity supply and withdraw the plug from the socket before cleaning the machine. Programme Washing symbol Fabric The washing machine must not be hosed down. Cottons, linens or cotton mix fabrics, e.g. table linen, towelling, underwear, T-shirts etc.
Page 9
Cleaning the drawer housing Problem Error Code Possible Cause Use a bottle brush to remove detergent residues inside the drawer housing. 1. The water tap is not open. 1. Open the water tap. “E1” is on The machine 2. The drain hose is put down. 2.
XQG60-A508K 220V-240V~, 60Hz Rated power Water pressure 64kg/68kg Electric Diagram 595X530X845 PTC Door Lock Filter PUMP Note: Data can vary from the nominal values given depending on water pressure, water hardness, water inlet temperature, room temperature, type and volume of load, fluctuations in the electricity supply and any extra options selected. Power Power Panel Symbol expalanation...
Need help?
Do you have a question about the 4160980M and is the answer not in the manual?
Questions and answers