Table of Contents
Advertisement
INSTALLATION
&
OPERATING INSTRUCTIONS
Serial Number of Heater: ____________ Model: ___________________
Coonara
WOODHEATERS ARE MANUFACTURED BY
SHAMIC SHEETMETAL
SHAMIC SHEETMETAL
SHAMIC SHEETMETAL
SHAMIC SHEETMETAL
(AUST.) PTY. LTD.
PO BOX 8, KILSYTH, VIC. 3136
PH: 03 9737 5300 FAX: 03 9761 6455
Revised: 10/05/2008
1
Printed: 22/04/2009
Advertisement
Table of Contents
Need help?
Do you have a question about the CCF3 and is the answer not in the manual?
Questions and answers
the flue will not open
The flue on the Coonara CCF3 may not open due to a buildup of creosote, soot, or ash, which can partially block the flue pipe and restrict gas flow. This can occur if the flue is not cleaned regularly. Proper maintenance, including annual cleaning and inspection, is necessary to keep the flue functioning correctly.
This answer is automatically generated
removing baffle - dead easy, replacing it wow... still out. Coonara fire box
To replace the baffle in a Coonara CCF3 firebox:
1. Allow the heater to cool completely before starting.
2. If firebricks are fitted, remove them as needed.
3. The baffle plate is held by four locating tabs—two on each side at the front and rear of the firebox.
4. Lift the front of the baffle upward.
5. Pull the baffle forward over the supports until it clears the locating slots.
6. Replace with the new baffle by reversing these steps.
This answer is automatically generated