Auto-Detection Scan - Code Soft MD2 Series User Manual

Auto-detection scan

Auto-detect sensor: By setting Enable, the scanner will start operating if any nearby object has been
detected. The laser light of scanner stops scanning when there is a successful reading or no code is
decoded after the Stand-by duration elapsed. Once the laser light stops scanning, the present object
must be removed to enable Auto-detect sensor.
Operating mode:
In-stand-auto-detection- The scanner must be placed in the stand to enable Auto-detect sensor.
Auto-detection-always-ON- Auto-detect sensor is always enabled regardless of the placement of the
scanner.
In-stand-continue- The scanner must be placed in the stand to enable the scanning mode to be set as
continue.
One step setting of In-stand-continue mode
Option bar code
Auto-detect sensor
Operation mode
Stand-by duration
Option
Disable
Enable
In-stand-auto-detection
Auto-detection-always-ON
In-stand-continue
00-99 (second)
24
SETUP
Alpha. entry
00
01*
00*
01
02
00-99
04*
END