Versitron M7250 Installation Manual

YOUR COPPER-TO-FIBER CONNECTION
M7250
Gigabit Ethernet
1000BASE-T TO 1000BASE-X
MEDIA CONVERTERS

Installation Guide

General
The 1000BASE- T to 1000BASE- X media converter series
provides 1000Mbps Gigabit Ethernet copper -to-fiber media
conversion, allowing for 1000Base - T-1000Base- X over
multimode or single-mode fiber optical media.

Specifications

Twisted-Pair Interface (Copper Port)
Connector Shielded RJ-45
Signal Compliance IEEE 802.3ab 1000BASE - T std.
Pin Assignments Auto MDI/MDI- X detection
Data Speed 1000Mbps
Configuration Auto-negotiation support
Cable Types Category 5 or higher UTP
Link Distanc e Up to 100 meters
Fiber Optic Interface (Fiber Port)
Signal Compliance IEEE 802.3z 1000BASE- SX/LX std.
Connector SFP for pluggable fiber transceiver
Dat a Speed 1000Mbps, full duplex
Cable Types MMF - 50/125, 62.5/125 µm (1310nm)
SMF - 9/125 µm (1310nm)
Link Distanc e MMF up to 500m
SMF -model dependent
Eye Safety complianc e IEC825 Class 1
Center Interface
Interface For center chassis mounting
Connector FutureBus

Features

Gigabit copper to fiber conversion: 1000Base-T- to-
o
1000Base- X multimode or single- mode fiber .
SFP design: For flexibility, an SFP (Mini-GBIC) connector
o
i s provided for the fiber port to accommodate any type
of SFP fiber transceiver when needed.
Support full wire speed copper to fiber conversion
o
Auto MDI/MDI- X detection function on the copper port
o
Auto-negotiation support
o
Plug and play : no configuration settings is required
o
Link Fault Pass Through: this function allows link fault
o
status passes through between copper link and fiber
link transparently.
Far End Fault function on fiber port
o
Transparent conversion to any type of packet frame
o
No packet length limitation
o
Diversified mounting support: desktop mounting,
o
wall mounting, optional Din-Rail support
Center chassis installation: support installation i n a center
o
chassis rack with
management and redundant power backup.
Support wide range of fiber options : multimode fiber,
o
single mode fiber (short reach up to long reach), Bi -
directional single fiber, and CWDM optical
Low po w er consumption
o
1 2
3 4
DC Power Input
Interface
Operating Voltages
Power consumption
Mechanical
Dimension (base)
Housing
Weight
LED Indicators
PWR ON
OFF
SFP ON
OFF
LINK ON
OFF
BLINK
OL ON
OFF
Environmental
Operating T emperature - 5 ~ 55
Storage Temperature
Relativ e Humidity
Approval
FCC Part 15 Class B
CE / CISPR 22 Class B
IEC60950 Safety
Refer to Model Optical Specification sheet for model
details. The documentation describes the detailed fiber
configuration, rated operating temperature, and optical
specification of each model.
benefits of central
DC Jack (-D6.3mm/+D2.0mm)
DC input +4.75V ~ +12.6V
max 2W @+7.5VDC input
W 108mm x D 72.5mm x H 23mm
Enclosed metal with no fan
205 g
Power on
Power off
SFP transceiver is installed.
No SFP transceiver i s installed.
Copper-fiber link up
Copper-fiber link down
Copper-fiber link with data traffic
Fiber port optical signal detected
Fiber port no optical signal
o C
o
- 40 ~ 85 C
5% ~ 90%
software