18 5.1 Speaker Setup; Lock (Parental Control) - LG HT355SD Owner's Manual

1 Installation
5.1 Speaker Setup
Make the following settings for the built-in 5.1
channel surround decoder.
1. Press SETUP.
2. Use U u to select AUDIO menu and then
press i .
3. Use U u to select [5.1 Speaker setup] menu
and then press i .
4. Press ENTER
The [5.1 Speaker setup] appears.
3
5. Use I i to select the desired speaker.
6. Adjust options using U u I i buttons.
7. Press RETURN to confirm your selection.
Return to the previous menu.
Speaker selection
Select a speaker that you want to adjust.
NOTE
Certain speaker settings are prohibited by the
Dolby Digital licensing agreement.
HT355SD-F0_DAUSLL_ENG_4784.indd 18
Size – Since the speaker settings are fixed, you
cannot change the settings.
Volume – Press I i to adjust the output level
of the selected speaker.
Distance – After you connect the speakers
to your unit, set the Distance between the
speakers and your listening point if the
distance of Center or Rear speakers is bigger
than the distance of Front speakers. This
allows the sound from each speaker to reach
the listener at the same time. Press I i to
adjust the Distance of the selected speaker.
This distance is equivalent to the difference
between the Center or Rear speaker and Front
speakers.
Test – Press I i to test the signals of each
speaker. Adjust the volume to match the
volume of test signals memorized in the
system.

LOCK (Parental Control)

Initial Setting of the Area Code:
When you use this unit for the first time, you
have to set the Area Code.
1. Select the [LOCK] menu and then press i .
2. Press i .
To access the [LOCK] options, you must
input the password you have created. Input
a password and press ENTER. Enter it again
and press ENTER to verify. If you make
a mistake before pressing ENTER, press
CLEAR.
3. Select the first character using U u buttons.
4. Press ENTER and select the second
character using U u buttons.
5. Press ENTER to confirm your Area code
selection.
2010-08-13 ¿ÀÈÄ 5:00:47